100004 | CoverMate® I / I Eco Replacement Pivot Arm

Q: Which cover lifters is this arm compatible with?

A: It is specifically for CoverMate® I and CoverMate® I Eco lifters.

Q: Does this arm include any brackets or hardware?

A: No. It’s the pivot arm only — mounting bracket, screws, and other parts are not included.

Q: Is the pivot arm side-specific?

A: No. It fits either side (left or right) due to its symmetric design.

Q: Why would I replace this arm?

A: It may bend under heavy loads (e.g. snow), become loose, or suffer wear at the stop. Replacing just this arm is more cost-effective than replacing the entire lifter.

Q: What material is used?

A: Powder-coated aluminum, which balances strength and corrosion resistance.

Place the cover in the closed position and ensure corners are aligned.

Remove the self-tapping screws on both ends of the existing pivot arm.

Unscrew the through-bolt from the mounting bracket.

Slide off the old pivot arm from the support arms.

Slide the new arm into place, align holes, and reinstall the through-bolt.

Reattach the self-tapping screws on both ends.

Test the lift motion slowly to confirm smooth operation and alignment.