Reductor de pH y alcalinidad para bañeras de hidromasaje: 1,25 lb de granulado para agua de spa

Product Type: pH and total alkalinity reducer for spas and hot tubs

Adjustment Method: Acid-based pH and alkalinity reduction

Active Ingredients: Sodium bisulfate (dry acid)

Form: Granular powder

Compatibility: All spa and hot tub sanitizer systems including chlorine, bromine, mineral, and salt systems; safe for acrylic spa surfaces and standard spa components when used as directed

Function: Lowers high pH and total alkalinity to help prevent scale formation, cloudy water, and reduced sanitizer efficiency

Application Timing: Use when pH or total alkalinity levels test above recommended ranges

Dosage: Typically 1–2 oz per 500 gallons to lower pH incrementally; adjust based on test results and water volume

Water Balance Impact: Directly reduces pH and total alkalinity; retest water after application before adding additional product

Maintenance Requirements: Routine water testing required to avoid overcorrection

Use Frequency: As needed based on water test readings

Dissolution Notes: Pre-dissolve in a clean bucket of water before adding to spa for best distribution

Storage: Store in a cool, dry place away from moisture and direct sunlight

Shelf Life: Approximately 2–3 years when stored properly

Safety Notes: Avoid direct contact with skin and eyes; do not mix with other chemicals

Pruebe la alcalinidad total y el pH actuales.

Agregue 1 cucharada rasa por cada 250 galones para reducir la alcalinidad ~20 ppm.

Haga funcionar la bomba/filtro del spa durante 15 a 20 minutos para mezclar completamente.

Espere al menos 2 horas antes de volver a realizar la prueba y ajustar según sea necesario.

Mantenga la alcalinidad entre 80 y 150 ppm y el pH entre 7,2 y 7,8 para una salud óptima del spa.