Tear-Aid Repair Patches provide a simple and easy method of patching holes and tears, as well as an excellent protective film solution. Each Tear-Aid Repair Patch is made from an exceptionally tough, matte finish, abrasion resistant, elastomer that resists puncture and tearing
The Tear-Aid Type A Fabric repair patch works on - Canvas, Rubber, Neoprene, Nylon, Most fabrics, Plastics, Polyethylene, Polypropylene, Polyurethane, Non-oiled Leather, Umbrellas, Gore-Tex, Acrylics, Fiberglass, Aluminum, Polyester, Hypalon and Dacron
The Tear-Aid patch is see-thru to work on any color and is UV resistant to prevent yellowing for years. It provides instant adhesion with no sewing, no glue and no mess. The patch also conforms to irregular surfaces and won’t turn gummy in high heat
Product Specification
Brand
TEAR-AID
SKU
ES-6425
Dimensions
3 x 1.26 x 5.5 in
Barcode
699337200056
Weight
0.07 lb
Directions
STEP 1. When applying underwater, apply to a smooth non-textured vinyl surface. Almost all pool liners are a good surface. Clean and scrub area larger than where patch is going to be applied to. Do not apply to an uncleaned area. Do not foul patch in a scummy water application. If patch is partially above the water line, clean dry area with alcohol prep pads using the dry application instructions. IT IS IMPORTANT TO SQUEEGEE THE WATER OUT FROM BETWEEN THE PATCH AND THE VINYL.
STEP 2. Cut patch to size with scissors allowing for the patch size to extend 1 inch beyond all edges of the tear. Trim square corners into rounded corners.
STEP 3. Do not foul the patch with your fingers, Carefully peel back ½ inch of paper liner.
STEP 4. Position the patch with the paper liner still on it underwater and anchor exposed ½ inch edge allowing the patch to extend 1 inch beyond all edges of the tear.
STEP 5. Slowly peel back liner while carefully rubbing down with your fingers. DO NOT ALLOW THE PATCH TO WRINKLE. IT IS IMPORTANT TO SQUEEGEE THE WATER OUT FROM BETWEEN THE PATCH AND THE VINYL.
STEP 6. Use a firm squeegee to rub from center of patch outward in all directions firmly. Do not pick at the patch. Full adhesion requires 24 hours.
